Filter by
All
Resources
Case Studies
Blog
FAQs
What do termites do to the foam?
EPS pro­vides no nutri­ent val­ue and is not a food source for ter­mites. If left exposed, ter­mites may tun­nel into the foam in search of fibrous food. When build­ing, in a heavy ter­mite infes­ta­tion area, care is required in the detail­ing and con­struc­tion of the walls that will be in con­tact with ground, to pre­vent access to the foam for ter­mites.
VIEW PAGE
Arrow1 right shadowLong arrow right with shadow
How do I apply traditional stucco to an ICF?

Tra­di­tion­al stuc­co has a thick cemen­ti­tious base, typ­i­cal­ly installed over a met­al lath. The met­al lath is fas­tened direct­ly to the Fox Blocks webs with screw or sta­ples.

VIEW PAGE
Arrow1 right shadowLong arrow right with shadow
What if my contractor doesn’t know how to build with it?
Fox Blocks offers the most com­pre­hen­sive installer train­ing in the indus­try. We can train your con­trac­tor or help you locate a trained installer in your area.
VIEW PAGE
Arrow1 right shadowLong arrow right with shadow
Can the plastic webs be detected by using stud finders?

A stud find­er typ­i­cal­ly uses the den­si­ty of mate­ri­als to locate studs. The polypropy­lene (plas­tic) web mate­r­i­al will show up on high qual­i­ty den­si­ty stud find­ers. Note, the webs in Fox Blocks are spaced at 8″ (200 mm) on cen­ter and will be con­tin­u­ous ver­ti­cal­ly on each side of the wall.

VIEW PAGE
Arrow1 right shadowLong arrow right with shadow
What is the typical Interior finish on an ICF?

All build­ing codes in the USA and Cana­da spec­i­fy that plas­tic insu­la­tion (EPS) must be cov­ered by a ther­mal bar­ri­er equiv­a­lent to 15 min­utes of fire pro­tec­tion in hab­it­able spaces. This is achieved with ½” gyp­sum board or an equiv­a­lent mate­r­i­al. Fox Blocks has spe­cif­ic fire test­ing that proves reg­u­lar ½” gyp­sum board with reg­u­lar dry­wall screws fas­tened into the plas­tic webs remains on the wall for the required 15-minute time peri­od.

VIEW PAGE
Arrow1 right shadowLong arrow right with shadow
Why is the concrete limited to a placement height or lifts of 4 feet (1.2 m)?
To alle­vi­ate the pres­sure from the liq­uid con­crete, the con­crete is placed in lay­ers or ​‘lifts’. The first lift is lim­it­ed to 4′ (1.2 m) of con­crete around the perime­ter of the build­ing. This allows approx­i­mate­ly one hour for the con­crete to set-up before con­tin­u­ing with the next 4′ (1.2 m) lift. The low­er lift pro­vides sup­port for the next lift as the con­crete is placed con­tin­u­ous­ly around the build­ing in con­sec­u­tive lifts to the top of the wall.
VIEW PAGE
Arrow1 right shadowLong arrow right with shadow
Are there different types of Expanded Polystyrene (EPS)?
EPS is list­ed basi­cal­ly under four prop­er­ty clas­si­fi­ca­tions – Type I, II, III and IV. The char­ac­ter­is­tics are based on the den­si­ty of the mold­ed foam which defines the prod­uct type. Fox Blocks ICFs are man­u­fac­tured as a Type II EPS with a den­si­ty of approx­i­mate­ly 1.5 pounds per cubic foot.
VIEW PAGE
Arrow1 right shadowLong arrow right with shadow
Is there a top and bottom on the blocks when installing the Fox Blocks forms?
Fox Blocks forms have a reversible inter­lock sys­tem on all blocks. The robust inter­lock allows the blocks to fit togeth­er very tight­ly, elim­i­nat­ing any require­ment for adhe­sives. A reversible inter­lock speeds up the instal­la­tion.
VIEW PAGE
Arrow1 right shadowLong arrow right with shadow
How does the ICF block get secured to the foundation?
The ICF blocks are held in place with either low expan­sion spray foam or a met­al starter track. The bracing/​alignment sys­tem, typ­i­cal­ly installed after the 4th course of block, also sup­ports the ICFs in place. Once the con­crete is in the wall there is no con­cern with the forms mov­ing. The con­crete is con­nect­ed to the foot­ing with rein­forc­ing dow­els.
VIEW PAGE
Arrow1 right shadowLong arrow right with shadow
How do I protect the ICFs below grade?

All ICF walls below grade, that have hab­it­able space on one side (base­ment), must have a water­proof­ing / damp­proof­ing mem­brane installed. For walls that do not have hab­it­able space on one side (crawl space, frost walls, etc.) the EPS can be left exposed to the earth. The EPS will not dete­ri­o­rate when exposed to the earth.

VIEW PAGE
Arrow1 right shadowLong arrow right with shadow